Forum: Tips and Techniques

Hello Forum, I'm new to the forum, but have gotten alot of great products from Eastwood in the past. I have a 20+ year old intake I would like to clean it up a bit. Any kits, materials that could be suggested would be great!

Posted a blog but got no comments. Still looking for an answer as to using paint remover on fiber glass fenders. I have some fractures that need repair and I heard the stripper will wick into the fiber glass and may cause problems with the final finish. Any thoughts?

Need some advice on how to most easily clean some metal auto parts that were damaged in our house fire last year. I had parts stored in Rubbermaid containers, and the heat from the fire melted everything. I was able to salvage some parts (that are structurally ok) - metal bumpers, engine intakes,...

GREETINGS I am planning to start restoration of 1989 Chevy Suburban. Lots of lower body rust out. My first resto project. I've had the vehicle too many years to let go ! Two questions, (1) When replacing rear quarter panel, etc. there are patch panels available but I don't see anything...

Does anyone have any tips on spraying Eastwoods 2K Uerthane primer? Should I thin it down for self leveling? If so how much? Im using it as a sealer going over spots of factroy paint, eastwood epoxy primer, and plastic filler. Im trying to give my self a sold bace to apply me color coats. Im...

I have some oil/grease stains on my exposed aggregate driveway. I've tried many different cleaners trying to remove them. Things like Simple Green, Purple Cleaner and a NAPA brand driveway cleaner without any luck. Does anyone have a good method of removing these stains? They are old and...

whats the best way to remove old bushings from my leaf spings and whats the best way to put in the new ones? thanks dan

is it better to bead blast or sandblast exhaust manifolds before using high temp coating paint? would you just use pre cleano after balsting or just blow the parrt off and apply the paint?